Wedding Pillow How To Make A Ring Bearer Pillow DIY Tutorial

Wedding Pillow How To Make A Ring Bearer Pillow DIY Tutorial


How To Make A Ring Bearer Pillow You will need satin, lace, lace trim, stuffing, silk flowers, hot glue sticks, and hot glue gun and/or sewing machine, and thread. Cut two pieces of satiin in a 10″ square for one pillow Now cut two pieces of the lace in 10″ squares for one pillow Lay one square of satin flat. Shiny side up and then put one square of lace (pretty side up) on top of that make sure they are even trim if necessary. Then flip it over and pin the backside. Now sew the two pinned pieces together one at a time I accidently showed this section over again while editing this! This is pinning the squares and sewing them Remove the pins and place one sewn square – pretty side up then take the other sewn square and put it pretty side down on top of the first one and pin together Sew together on three sides On the fourth side only sew 3/4 leaving a hole big enough to put your hand inside take pins out Put your hand inside and turn inside out Stuff the pillow with stuffing Sew up the hole take a needle and strong thread or embroidery thread and run it through the middle of the pillow and back Cut thread, pull tight and tie in a knot Glue or stitch on trim lace Glue or stitch on silk flower

Leave a Response

Your email address will not be published. Required fields are marked *

12 thoughts on “Wedding Pillow How To Make A Ring Bearer Pillow DIY Tutorial”